Generator Shed - Combining Generator Covers While Running & Generator Covers for Outside Storage into one. The Generator Running Cover Built On An Enclosed Steel Frame

Nice.\, looks good, perfect for protecting your generator, access when using very good.The only issue the directions for assembly can be a little difficult.I would recommend for keeping your generator outside.

This is so perfect for our generator!! Looks nice and clean next to deck. Easy to use! Velcros on and fits nicely. My husband was going to "build " a cover" that prob would have been bulky and not as compact. Worth the money!!

The cover was a perfect fit on a Firman 7500 Watt Dual Fuel Generator. Good and not excessive clearance all around on the inside. About 2.5 inches clearance from the ground to give good protection from the rain, but allow you to move it easily.Tools and the bolts are a problem. The provided wrench strips the nut since the wrench fit with the nut did not seem tight enough. A better wrench is needed. You can get good tightening of you use your own socket (7mm). The bolt could also be a better quality. The provided Allen wrench seemed to strip the bolts when tightening. If the bolts are snug, the nut side only can be tightened. It would also be helpful if the parts were labeled with stickers (A, B, C, etc.).After assembly it is a good quality.

It was a little difficult to put together, but I think it will work well in rain or snow. Overall, I’m satisfied with it.

The instructions for assembling was absolutely amazing. Very easy to assemble. Very sturdy and fit generator perfectly.

While the assembly instructions could be better, the product itself is excellent. Do be careful to avoid sharp edges. Quality materials are used for the aluminum frame and cover. With lots of Velcro there are multiple configurations for use while the generator is running. Highly recommend the model with a peaked top to aid water shedding. Should work with most portable home generators.

The most convoluted , terrible directions. This seems like a great design—metal frame etc…but then they provide garbage plastic corner hardware, i recieved 2 broken ones (should be made of extruded aluminum). I knew there was some velcro involved but this is ridiculous as it is the velcro STICKERS (the velcro sticker s DO NOT STICK CORRECTLY)that squares the frame (should have metal angle brackets to help square the frame (frame must be square to put on cover! correctly). Center roof supports should be held in place with bolts NOT velcro. Fiberglass rods for roof should lock in place not be held in place by velcro stickers. I had to use duct tape to secure correctly. There is no over hand on roof edge so guaranteed to LEEK WATER in rainy conditions— in terms of storage of generator i would put another cover on generator before putting shed (take off for operation). This is not adequate protection for a running generator. Much better off building a better quality permanent small building to house running generator. This shed is only useful temporarily and if i could return it i would packed in a garbage bag.

Just installed it on my 13,000 KW generator and it fits pretty much perfect . The components are well made and fit together nicely. Well thought out design.