We believe that threading the barrel of the Mosin Nagant is the most effective method to install a muzzle break on your Mosin Nagant because their barrel are not always concentric. See the picture above. There are many breaks on the market that just mount with a bracket secured behind the front sight that end up being shot off with an exiting bullet and are potentially dangerous. Designed for tactical applications that require minimal dust signature. A massive symmetrical blast baffle, redirect gas to the sides and upward delivering unparalleled recoil reduction while also minimizing muzzle rise and ground disturbance. Type: Muzzle Brake Length: 3.189 inches width : 1.25 inches Exit hole .340 inches Machined from top quality steel and finished in black oxide. Thread alignment tool: This is a simple TAT (thread alignment tool) for re-threading 7.62 caliber muzzles to accept the above M15 X 1 RH muzzle device. The extended 3" long stem helps with Mosin-Nagant barrels which have been counter-bored to renew the muzzle crown.. It helps you get the die started level and on-center to prevent costly mistakes. Material: US made 303 Stainless Steel #5 Die Handle This a heavy duty #5 die handle is approx. 11.5in long and accepts 1.5in dia (38mm) dies like the M15X1 RH die that we offer on this site. These are high quality handles made of high tensile steel. * The Russian arsenal sometimes counter-bore the barrels to prolong their life by cutting out the bad/worn rifling at the muzzle end. If done properly a counter-bore has the potential to improve accuracy. The length of the counter-bore depended on how worn the muzzle end was. You should measure the depth of the counter-bore to make sure that this tool is long enough to reach the caliber bore of the rifle. PKG Content: 1 Threaded muzzle break 1 M15X1 RH adjustable Die 1 Thread alignment tool with a 3" long stem #5 die handle 1 Jam nut
Trustpilot
1 month ago
1 week ago
