WeiSen 8x Ring Bolt and Grip Thread Head Quick Lock & Ride Tie Down Anchor Kit Compatible with All Polaris Ranger/General Bed UTV ATV

Kept coming loose. Had to put washer on bottom. Now it works fine.

Liked all

EDIT: Just hope that you don't have to deal with the seller; DaSenllc.Having ordered 4 sets of 8 anchors (32 anchors total) I came across one damaged T-nut. I attempted to return the item via Amazon but the seller required the purchaser of the damaged item to pay for return shipping. I contacted Amazon Customer Service and they initiated a message to the seller clearly stating that "I request you to sent a prepaid return label". The seller asked for photo evidence of the damage and, although it took some time during the holiday season, I supplied the requested pictures.After doing so the seller refused to return the item - unless I paid return shipping - and otherwise only agreed to refund the value of the SINGLE damaged anchor; although it was a SET of 8. They even stated, "you don't need to send that back, because it is damaged item. it is useless."... Yes, a set of useless to me. Thank you for clarifying that.The seller also stated "now your order has been over one month return window" even though it clearly states "Return eligible through Jan 31, 2023".Ordered Nov 28.Received Dec 5.Discussion initiated by Amazon rep Dec 18."Over one month" statement made on Jan 5.I have now contacted Amazon Customer Service again and they have requested, yet again, a prepaid shipping label be sent to us. What a hassle.It's not the end of the worlds. I only wanted to share my experience for others. I don't recommend buying from this seller (DaSenllc) in the event that you may need to return a defective item.OriginalI just installed these and am working on other installs at the moment so I haven't gotten to test them out.I wanted to add L-track to my 2023 Polaris Ranger but I didn't want my first mod to be drilling into the bed. I used these to hold the L-track in place.I used one anchor in every hole in the bed; 6x on each side & 9x on the front wall.Notes:Bolt = zinc 5/16" x 2.5" Phillips driveNut = zinc 5/16" long 4-prong furniture nutTop washer = 5/16" x 1.5"Modifications:I added a ⅜"x1.5" stainless washer to the bottom of each anchor. ⅜" - not 5/16" - so that it fits over the nut. I used a bandsaw to but 4 outside slots and a dremel to cut 4 inside slots. The nut should fit into the inside slots then flare the outside slots. Make sure you flare these slots in the correct direction to add grip when you tighten the bolt from the top. If you use anything but stainless for this modification it will rust at the cuts quickly.I didn't end up using the knobs from these so I used a die to cut L-track studs from ⅜" to 5/16" and used the handles for those.Next I will be building a removable bed rack.

when tightened down rock solid hold

Thank u

They are too easy to pull out. When cinching down a load, they pull out. They do not lock into place well enough.

Bought these for my Polaris ranger to hold my LED whip lights. They were easy to install and quick to install (Note* I already had my LED whip lights wired up.) so making the install was quick and easy. Just put them into the holes that are already on the UTV. turn the knob until they are extremely tight. Add you LED whip lights and your done.I would recommend these to anyone looking for a product to hold you UTV whip lights or flags.

Like the product, fits in 2015 ramger good, take apart and put bigger washer on bottom, otherwise it will pull thru