YonicoRound Nose Core Box Router Bit Set 4 Bit 1/2-Inch Shank 14461

These are a quality product, i have used them with no problems.

I am using these bits in my CNC. I started with the 1/2 inch bit and found that I really needed a larger bit. What is nice about a set is you have the bits without having to buy another. Great price as a set. The 5/8 inch bit has seen a good bit of use and is still sharp for my projects.

They were a nice set to purchase. Gave me a variety to use. I would purchase again. I have used three of them so far. They are great when they are sharp. They do stay sharp for a while. On bigger projects you will either need a couple or a way to sharpen. They don’t stay sharpe forever. And these are a 1/4” shank. If anything goes wrong while routing you will most likely bend the shank and it’s a dead bit. Happened to me. It would be best if you were using a 1/2” shank. My router is not a 1/2” shank. Not sure I can find the part to change it as it’s a older dewalt plunge router. Just beware of the limitations. I had read that 1/4” shank bits for this use you were taking chances.Obviously I was not paid nor do I receive any benefits writing theses reviews. I do it to help you the real users of products.

I bought these router bits to cut juice grooves in my cutting boards. These cut all the sizes I need, and they cut clean grooves in a variety of hardwoods.

I bought this set recently thinking that it would be of good quality given that it was priced slightly higher than others. I was disappointed to find out that the bits easily overheated. The protective coating partially peeled off almost immediately and the groove was left with too much burn marks. I suspect that the bits are not sharp enough (or correctly). This does not happens with my other bits (same function) which my wife bought for me at a garage sell.

These Yonico router bits are quality parts at a fraction of the price for name brand bits. They run true, with practically no vibration, and the cut smoothly and without burning in both hard and soft woods.

I made these four bowls with the second to largest bit. It seems like I could use it quite a bit more before I would consider it dull.Make a 1/4 inch template for the top and use painters tape on the workpiece and the template with CA glue to hold them together to easily remove the template when you're done routing.Send me some free stuff and I'll try it out... I purchased these.

Good bits and reasonably sharp. I have used the 1/2 bit and it cut Baltic Birch with ease and had a good clean cut. I made the cut in one pass as the groove needed to be 1/4 in. deep. The bit plowed through the wood with ease. The bottom of the groove was symmetrical and clean. I have no hesitation recommending these bits for the DIYer. I did not give 5 stars as I am sure there are better much higher priced bits. For my uses..... it is a 5 star.

great quality and very sharp.used it for window faceings

Muy buenos

La verdad no son tan buenas, pero finalmente estás pagando x un producto económico y es k les falta filo pues el corte no lo hacen limpio

I have only used them with mahogany and they did the job perfectly...

I use them for high speed router. CNC milling. They do the job and last long time.