PWM Fan Splitter Adapter Black Sleeved Braided Y Splitter PC Fan Splitter Cable 4 Pin/ 3 Pin Fan Extension Power Splitter 1 to 3 Converter/ 1 to 2 Converter 10.5/10.8 inches (2 Pack)

So when I bought this it was a little under $7. It came packaged nicely, the splitters themselves are of great quality. Nice braided splitters these seem like they will last a long time and work like they should. I 100% would buy again if the price was the same as when I bought them. I'm giving this review based on what I received and the price I paid. Now what bothers me is I liked this product so much that I went back to buy some more today only 2 or 3 days later and it was $10 dollars higher! So that makes it $16 and some change almost $17. Although I love this product I can not recommend purchasing this product at this price, especially when Amazon has so many to choose from for much cheaper and even some known better brands that made the industry standard. I would however recommend this product to anyone and everyone if the price drops back down to what I paid or even a little higher.

I used both of these, removed 5 cables, added two, for a clean very nice look!

These are good quality cables and very flexible. They’re also long enough to get the job done.

For the price under $10, these adapters are absolutely perfect! The kit comes with two splitters inside, one is 3 to 1 PWM and the second one is 2 to 1 PWM adapters, both are very well done, with cables covered by braided mesh and you can hardly see them underneath. The PWM male and female headers are also very sturdy and are fitting both 4 pin PWM and 3 pin none PWM fans, naturally you will not be going to be able to control the RPMs of the 3pin fans, but at least you can power them. As for the 4 pin ones, the motherboard can now control 3 fans with the same rpms or 2 fans, depending on which adapter you are using or your personal setup.The length of both splitters is about 10.5 inches and I think its plenty long to route behind the motherboard tray in the case and have the cables well-hidden for a good and clean cable management.Overall, I can highly recommend those adapters, they are very well done and super useful if you are aiming at the perfect setup.

I had run out of fan connectors on an ASUS motherboard, so one of the fans was dark and not spinning on the front of the case. I used the 1 to two cable on that computer to let the last fan run. I was a little concerned about using the fan expert software to tune jointly the two fans, but when it was done, they were both spinning. I think this is a good solution. It could also help solve the situation where you have enough fan connectors on the motherboard, but the fan cable isn't long enough by using the cable as an extension instead of a splitter.

Due to my case having more fans then motherboard fan headers I needed this fan connection splitter.). I only needed to use the four pin (1-3) splitter for my fans as the RGB fans already have an extension for the ARGB but not for another fan daisy chain connection. These splitters are colored cables with the braided loom over them. There is glued heat shrink on the connector ends as well as where they split from one to 3 wired connections. You can only notice the colored wires at the connector to the motherboard side when bending the wire for proper cable management but its not too bad as it matches the USB front panel connector right beside it.

The Cables are fine, actually high quality for such a random item. Just be careful to not pull to much current from your motherboard.