MUSETEX ATX PC Case Pre-Installed 6Pcs 120mm ARGB Fans, Computer Gaming Cases with Type-C Port and USB 3.0, Mid Tower Case with Mesh Front Panel and Tempered Glass Side Door, Y4

This case is great. I got it in the mail and automatically started to assemble my pc inside of it. The first thing you’ll notice is how much space you have, and with the swing door being detachable, you can really work around inside and cable manage with the back end. The rgb fans are quiet and durable, I’ve been running this case for a while now with no fans starting to squeak or anything. This was the final piece of my setup and really livened up the aesthetic. Not to mention, I actually received 5-10 degrees C less heat on my internals due to the supreme airflow. A truly excellent purchase.

Some things I want to say the pro and the con so far.The Cons:Not enough space for cable management( or I suck at it) and it is decent size but you got to remove the rare and top fans so you can install the ATX motherboard and think it atx micro motherboard will be right for this PC case. Make sure you got the right GPU size that are two fan not the bigger GPU with three fans.The Pro:The quality is distant and the design is beautiful. You get very good air flow, it not too heavy and can fit right any space you need for your office or gaming table. Also good customer service, they will email you for important info you need to know. I'm looking more new products from them in the near future.

This is a very nice looking case. I got everything set up. Then I discovered that the rear fan doesn't spin unless you give it a nudge with your finger. I tried plugging it into a couple of different connectors on the fan circuit board but as I switched connections the problem remained with that particular fan and didn't switch with the connections. Also, I removed the fan from it's mounting to determine if it was something in the way it was mounted to the case. But removing the fan from it's mounting on the back of the case, made no difference. So, by simple deduction the problem with the fan not spinning properly, is a problem with the fan. I'd like to just replace the bad fan, but I don't see any option for this type of product support. Since I have the rig built now, I'd rather not return the whole case, when a new fan would most likely solve my problem.If the manufacturer reads this review, perhaps they could contact me about solving this fan problem without a costly (for them) and time consuming (for me) solution.

Good sturdy case. Sadly came with one bad fan. There's barely room for cables in the back. I would suggest a modular power supply.

Really nice case. Well built and it comes preconfigured with fans, zip ties, and Velcro cable ties. The size is nice and the glass door quite heavy. Nice hinges and the door lifts off without issue.My only problem is that it won't fit a Zotac 3080. This 3080 is just a shade over one foot. The interior of the case is one foot. However, with the motherboard setup, there's not enough room the slide the 3080 in over the lips of the case.We ended up disassembling the whole computer and re-using an older but much larger case.And, of course, I'm three days past my return window.Otherwise, it's a solid, well designed case. I would encourage users to check the measurements and take into account that the case lips won't allow you to fit a full sized 3080 card in there.

Bought a Predator Orion 3000 from Walmart and the case had little to no airflow. Bought this case to transfer all internals over. Case works awesome, though I had to buy a new motherboard because the Orion Motherboard was custom to that case. Case comes with 6 fans connected to its own controller and RGB is based on the Case alone. Cannot control RGB through Motherboard and apparently my motherboard did not come with a speed sensor for the fans. But, on my base case I was running around 70 to 90 Celsius and on this Musetex Case I am peaking around 35 to 50 Celsius. All in all case has way better airflow and design. Graphics Card is running better and more quiet also. Badass anesthetic's and way more design for RGB light ups and Display. All in All, I would recommend this case to anyone looking for a Mid Tower case with awesome airflow and design.

Helped my son build his first gaming computer, and he selected this one, based on the reviews and photos. It is just as described. Very well engineered, with great wire management options. Not sure how great the fans will be over time, but easy enough to swap those out if they start to fail. No noticeable issue with heat so far, and he's got a pretty hot processor and GPU in there, it seems to have great airflow. Looks great too. I love the magnetic door closer. The removable (washable) mesh covers are a nice touch. Very happy with this, and was a great value for under $80!

Used this case to build my friends first PC. He absolutely loves it! Not only does it look awesome, but the value is insane. The highlights are definitely the USB-C port, the side clear glass window that closes and opens on a swivel with a magnetic seal along with the INCLUDED 6 RGB fans that are surprisingly quiet. Very impressed by this case indeed.