ROADER Front & Rear Inner Fender Liners US Flag Pattern Liner for 2007-2018 Jeep Wrangler JK JKU Unlimited Sport Sahara Rubicon 2/4 Doors

They look good and bolt up well. They arrive in the same box and it’s very well protected for shipment. Pay close attention to the instructions or it will cost you extra time.Let’s see how well they hold up to some road miles! Cheers!

They look great! They take a little time to put together but are fairly easy to install. Take your time and do it right.

The assembly is simple- so of course it may be a challenge for some. Simple has a way of becoming complex.. so don't over think it. The fronts are very nice and offer a lot of protection, but the rears.... not so much. There is a slight protection to the fuel filler lines, but other than that, not really effective. I would have only gotten the fronts had I known the minimal coverage the rears had. That said, the included hardware is stainless, and it took less than an hour to install front and rears. For the price, a good value.

Ordered these waving American flag inner fenders for my Jeep. The flags on the passenger side ARE facing the correct direction. When these were delivered, I realized the aluminum plates that go behind the flags were unpainted (I was happy about this). I ordered paint to match my jeep so I could paint & also put a clear coat on them before installing them. All the holes lined up perfectly. Install was very easy. Seems like a sturdy product. I love these!**I did purchase black bolts/screws to replace the aluminum ones they sent, because it gives it a nicer finished look. Only thing I could suggest to the sellers of this product is to change the hardware to black.

The instructions are pretty awful. Just pictures. And the pictures don't give step by step. And they don't show both sides laid out. Having said that. After several restarts, it turned out to be not too bad. BUT, not very easy. Other than that, the front inner fender looks great. The rear inner fender leaves too much exposed. I think I'll end up spray painting the wheel well just so it isn't quite so obvious. As it is, it just looks like a piece of metal on top of the body... which it is... but it just doesn't look great. I'd almost rather buy the front only and then simply paint the rear wheel well black. that'd look just as good and maybe better.

The instructions are confusing. The 3 different sizes of bolts for no apparent reason is too much. Theres washers for the front but not the rears? The self tapping screw locations on the rear dont make much sense. One of them goes through the wheel well and the end of that screw sticks out inside the cab. Its under the carpet so it's hard to notice but I dont need my kids accidentally getting stabbed by a screw while simply sitting in the backseat. The front didn't even meet up with where it told me to attach it. I ended up buying M6x10 and M6x20 black hardware and used those instead. If I could go back and not purchase these at all, that would be the best route I took. The front I can live with. The rear that hardly covers anything are coming off in a few days.

These are thick, sturdy, and cool to look at. Curious if the picture on it will hold up but I love them! Great price, great fit, great choice if you're debating on this or something else

Removing inner fender cover exposes a lot of open crevices and wiring. The new cover does not cover these items. I know why in the videos they show the drivers side. It’s a lot easier. Instructions suck but with a little patience it can be done in an hour for the front only.