Vamos Tile Long Hexagon Peel and Stick Backsplash Tile - 10 Sheets Stick on Backsplash for Kitchen and Bathroom 12.4 x 12 Inch Beige Slate Look PVC Self Adhesive Mosaic Wall Tiles

Matt tiles feel really good and sturdy the adhesive sticks really well if you have smooth texture on the walls. I am not sure how this would work on textured walls. I have not tried it yet. I like how the bathroom just looks a little bit more put together the picture I have attached is of how it looks so far without finishing the edges, but I really like how it’s looking. Not very expensive and they have so many different options to use. I’m honestly thinking of purchasing more tiles to do our kitchen. They are a little bit tougher to cut unless you have a really good utility knife handy

The best alternative. Did a revamp of our laundry room used these as the back wall. They are so nice and easy to work with. Once they are on they are not coming off so place accordingly.

The media could not be loaded. Great product BUT could not find tile spacers narrow enough anywhere. I ordered three different kinds and none of them were small enough. No spacers come with the tiles. I bought four boxes and no spacers to be found. I think they are 1mm but could not find them so I improvised and cut an old credit card into strips and used those. They were the perfect width.You must be SO careful when placing these tiles as once one of them grabs the surface there’s no adjusting them at all. I would peel each backing almost all the way off then stick it back to loosen it, then I’d fold a few inches of it back and at an angle so I could set the edge of the tile carefully in place and peel back the backing slowly as I made sure the remaining tile was at the exact spacing needed. It is not a quick project. Measure everything four times before cutting and sticking, LOL!To tile my backsplash which is about 37sft it took me about 16 hours to finish. I installed over formica with no issues.To make my install easier I didn’t trim the bottom of each tile at the counter, I simply finished it off with shoe molding which covered the gaps perfectly and gave it a nice finished look.This product cuts easily but have a sharp razor knife with extra blades handy, a metal straight edge, a level and a flat cutting surface. All you have to do is do an initial cut, carefully score it deeper for a second cut then snap back and the tile will break. Turn the tile over and cut the foam adhesive side to have a clean cut. One cut can be sufficient, I’m just not that strong and it was easier to make two cuts to get the cut deep enough for the tile to snap cleanly.Because the tiles were relatively thin I just loosened the screws in the electrical outlets and wedged small tile scraps under them to bring the outlets to the same depth as the new tile surface.Pro tip!! If you have old brown or old ugly outlets you want to make look new, buy outlet colorcaps. All you have to do is remove the faceplate on the outlets, put the new caps over the outlets then put the plates back over the outlets and they will appear brand new and in my case updated my ugly brown plugs to a modern day bright white without having to do a bunch of rewiring!!Special note: if you have an old house like I do, its a challenge to get the tile to look straight (since my countertops are NOT perfectly level), but I was successful. I think hanging this tile vertically vs horizontal will be much more forgiving and disguise an any height differences of the tiles at the bottom.

The tile looks great in our guest bath and was fairly easy to install. It is VERY sticky so make sure you have it placed perfectly before you let it stick to the wall. I only gave it 4 stars for two reasons: these tiles do not come with spacers and we couldn’t find any at the hardware stores that were narrow enough so we had to freehand it. This caused us to have to remove and replace a few tiles using a blow dryer to heat up the glue. Our drywall still got damaged. Next, there is no lip on the edges so you’ll need to paint the wall black to avoid light spaced where two separate tiles meet. The whole process was much fast than traditional grout tile and we are pleased with the finished look.

We love how this turned out! I was nervous at first about it looking cheap, but the sheets have a nice weight to them and they feel and look like real tile. They aren’t easy to cut through, which made installation a little tricky. They are reinforced with two thin metal layers. I don’t understand how these could possibly peel off unless you didn’t clean the wall first. Once you lay them in place they are STUCK! Super easy to clean too. It took my husband and I about 3 hours from start to finish, mostly just because the cutting was slow and we were taking turns watching our 6 month old. I’d recommend these to anyone looking for an easy and cost effective way to spruce up their home.

incomplete package, open box.

The tiles are very attractive and they stick very well! They are well-made and resemble ceramic tiles. The quality is very good. I would buy this product again.

The quality of this tile is top shelf! I am in the middle of the renovation of a vintage Airstream. I am using it in the kitchen area. The tile sheets have a thin layer of metal along with a foam sticky backing so it is not thin and cheap looking! As a diy’er this was easy to install. I love the finish… not shiny!! This stuff will definitely go on my go-to list for reno products!