Button Switch Rocker Switch Toggle Switch Four Pin Two Position ON/Off Prewired Power Transfer Switch with Mounting Plate,Waterproof Cap.

This product is perfect for my needs. I am using it to extend or retract a linear actuator (up or down) and the DPDT toggle switch is high quality. The switch is prewired making installation super simple (red to red, black to black) The fact that the mountain plate has "UP and "DOWN" marked on it it simply ideal..

Works Great

First off, this is a very industrial switch and I really like the quality of it, but it did not exactly suit my purposes and I had to modify it. An important thing to realize with this is the pre done wiring is not done with slip off connectors, they are soldered and covered with shrink tubing. In my first picture you can see I had to cut off the wiring, and then melt the soldered wires away to expose the prong connectors as seen in my second picture. The reason I needed this switch was because I swapped throttles on an older boat and the old throttle had the trim switch built in, so I needed a replacement. With this particular aftermarket CMC power tilt and trim unit, it has a set of relays that control it and all you need to do is make contact between purple (live power) and green to go up, and blue to go down, so essentially I just needed the positive connections with no ground. As you can see in the third pic, you place the live power (purple) in the middle and when you flip the switch down, it makes contact with the blue, and when you flip up, it makes contact with the green. You only need terminals 4, 5, and 6 to do this. As a last note, this older boat had a wooden dash, so be aware you may have to chisel out if you are placing the switch in something relatively thick. Overall a great purchase but I wish it would have clearly stated the wires were pre-soldered on which made it a pain to modify, and in addition there was no guide on how to actually wire the thing which was very annoying.

Product arrived well packaged and in time. Looks to be of. Dry good quality. Will use again if needed.

worked fine

worked great to replace an old recliner switch.

It illuminates when powered - as it should. The faceplate makes it easy to slightly over-size the rectangular hole you need to cut in wherever you are mounting this, without having to be super-precise. The four screws for the faceplate are just long enough. I like this device. Great value.

No issues but for my application I had to but an exterior electrical box and custom fit to a box plate.I also bought another switch later which works well and comes with its own box.