Windshield Washer Nozzles Kit, Washer Jet and 2 Meter Fluid Hose with Connector, Windshield Washer Hose Kit Compatible with Chrysler, Dodge, Jeep, Replaces OEM #: 4805742AB, 5113049AA

The kit comes with everything you will need they were a little bigger then holes in the hood had it enlarge a little and there's no hight adjustment and shoots a litte low

To install, you will have to be a little creative. On the Jeep grand Cherokee, the tubing is a harder tubing (not quite as flexible as this material (Rubber hose), but it can still work. What i did was cut the harder tubing near the drivers side of the hood I then heated the tubing and inserted the straight coupling (made it easier with the tubing hot and sealed good when it cooled). I took the flex hose and measured to the new nozzle location. I then inserted the T coupling and ran a small piece of flex tubing directly to the nozzle. I then measured and cut a longer piece to go to the passenger side nozzle. All good now and sprays the windshield great.

Review is for a 2013 Chrysler Town and Country.I read the reviews, watched a few you tube tutorials, and thought this was what I needed. However once the new nozzles snapped into place they were snug and it was impossible to adjust their spray aim. I tried to pry the plastic tabs to adjust but they are hard to take out again without breaking them off. I'm going to try another brand and see if they are better and probably return these. Right now they are staying until I get a replacement for them.Install tips: Taking the old nozzles off the plastic completely crumbled, so there is no going back to those. I saw other reviews saying the tubing was clogged with debris, so I squirted my wipers a few times without the nozzles to clean out the plastic crud. Those OEM nozzles just became brittle and fell apart when I tried to squeeze the tabs with the pliers. Lots of crud stays inside the line - clean out with a screw driver as best you can, hold it upside down and top them out, and then spray the wipers several times to clean out crud before hooking up new nozzles.

2012 Ram p/u needed a new emitter (replaced both, of course). Total time, maybe 15 minutes. Good replacement, sprays better than the original set. What I did learn is this: Prior to installation, use a very small set of diagonals and cut at the top of the 2 plastic "insets" (next to the emitter) which hold the emitter in place on the hood. This frees up the bottom part of the insets and allows it to open better at the top and guide into place with a solid, effortless snap.

worked just fine........ a nice mist spray

"compatible with 2013 town and country" more like "you can make it work"Hose is bigger than the factory hose so it isn't compatible with the original clips under the hood to hold it in place and you have to cut a tiny length of hose to connect the T to the nozzle which means it hangs down a couple inches. Can't complain much for $8 though.

I bought these to replace the original nozzles on my 2016 Chrysler Town and Country minivan. The installation took a matter of minutes.The only issue I had, which was a little frustrating, was some erratic spray after the installation. However, I quickly discovered this was *not* a fault of these nozzles. A tiny speck of plastic that had come off the original crumbling nozzles when I removed them had gotten in the line to one of the replacement nozzles. Flushing it out solved the problem, and now the spray from these nozzles is perfect. If you install nozzles and have a spray that isn't quite hitting right, I strongly suggest you try making sure they are free of any tiny specs of debris.I had no trouble at all getting them aimed perfectly, which a few people had said they had to deal with when installing new nozzles on their vehicles.This product was a quite inexpensive fix to substandard windshield washer spray on my car. I just wish I had done it sooner than I did!

My mechanic took off the broken one, put this on my car. And it worked great. I did not know it was broken until, he looked at it and saw it. Plus you get 2 of them. I went to O'Reilly's to purchase just one, it was about $35.00, I looked on Amazon and got 2 of the exact same thing for $6.11. I politely took the one I purchased at O'Reilly's back.