Pipishell Speaker Wall Mounts, Dual Side Clamping Bookshelf Speaker Mounting Bracket, Speaker Mounts for Surround Sound, Bookshelf Speakers up to 50 lbs, 1 Pair

This set of speaker stands is well designed and built.My speakers weigh only 11 pounds each, but I am confident these stands could easily handle their full rating of 50 pounds each. Fit and finish is impeccable, powder coating is uniformly thick and even, hardware is high quality, and instructions thorough and clear. Even customer support allows you to speak with a real, knowledgeable human at their actual manufacturing facility to answer your questions.Best of all, these stands are almost infinitely adjustable to meet any reasonable placement of your speakers.In short, I have not experienced any product so thoroughly conceived--let alone at such a ridiculously inexpensive price point.

I have these holding a pair of R-40M mounted to the wall on each side of my tv. Installed pretty easily with a drill and impact driver. Adjusting them is a bit strange, but not too difficult. Speakers felt sturdy when placing them into the slot. I anticipate these will last for a while.

Purchased to mount my Sony Core SS-CS5 speakers (7x8x13, 10lbs). They come with 4 very large lag bolts of good quality to mount to studs, as well as anchors for masonry/brick walls. The speakers fit fine, and they would accommodate much larger speakers. There is plenty of adjustability. The base has just a little wiggle when the speaker is secured, but as long as they're level I'm not worried about the speakers falling off. I'm not sure I'd trust it to hold more than a slight tilt in the long run without something more to secure them to the mount. The mounts include small strips of velcro to secure speakers to the mounts, but they're so short I don't know what good they'd do most people. I purchased a roll of .75 inch velcro and made straps to provide additional anchoring just as a precaution.One thing to note if the speaker arms have a small hole I assume is to route the speaker cable through to keep it from pulling the wires if you adjust them. These holes are too small for banana plugs, so if you want to use plugs and ever want to relocate/replace the wires, you'll have to disassemble the plugs to pull the cable out. Not a big deal just something I thought I'd mention.Would purchase again and recommend to a friend.

These will hold a small child. They're rated for 50lbs! I bought these in an emergency situation, where the cheap speaker mounts I had been using were starting to bend and give out. Well the last thing I want is my speakers to come crashing down onto various objects around the room. These were half the price of the ones that said that were specifically for Klipsch.The only issue is that they're made for square sides and my Klipsch Reference speakers taper to the back, so they can't sit flush against the sides of the clamps. But they do a good enough job despite that, and are never going to give out.Oh, and I love how adjustable they are. I will turn the speakers towards the place I'm going to be sitting and I can turn them right back.

I'm using these with 5 inch studio monitors and they do a great job. The lag screws seem a bit overkill, but these things can definitely handle heavier speakers than mine, and some. The parts all seem high quality and well built. I highly recommend these wall mounts.

These bad boys are strong!! My speakers are 22lbs a piece, but these wall mounts hold 55lbs!! My carpenter found the studs in inside the drywall and boom, no problem. They rotate, tilt, easy to maneuver, come with hardware and under $40 for both!! Amazing deal!

I needed a lot of rotation so I could attach them to the sides of my desk unit, as opposed to the wall. These provide 360 degrees. They also provide the leveling adjustment I needed. The side panels that squeeze together via screws to hold the speakers in place work very well too, although the rubber lining only covers about half of the panel. The only improvement I see then would be to make those panels a bit taller with a rubber lining that completely covers them for a really solid grip. There are screw holes, but I'd rather not use them.

My husband purchased these to mount his speakers on the wall. I'm not a fan; they extend too much. I would gave preferred something that's flush with the wall.