JACKJAW 200 Concrete Form Stake Puller - Effortless Extraction Tool for Contractors - Easily Removes 3/4” and 7/8” Stakes - Made in USA.

I was truly impressed with this stake puller it's lighter than ones I have used it is a bit pricey that may make some people choose a cheaper solution if you are I would suggest staying clear from the bon tool choice it is alot like I what we used to build on the job site I same design just not engineerd right if your stake is in sand and not up against a form it might pull it out otherwise don't bother this jaw jack pulled 3' round stakes out of a pier that didn't seal around bottom and lost all the mud out some as it was vibrated but no one took a shovel to wet mud and when it was stripped I was thinking we cut them off and drive it in . Only had 1 out of 8 we had to do a little chipping on. They weren't easy but how it's designed to get next to form the cost is made up just in the labor of bending it up just to get loose to then waste time with any other puller I have seen a clean efficient way to get a often pain in the ass job done