Creality Ender 3 V3 3D Printer, 600mm/s High Speed with All Metal Build, New CoreXZ with Dual-Gear Direct Extruder, 60W 300℃ Hotend, Auto-Leveling DIY 3D Printers 8.66x8.66x9.84 inch

A great intro into this hobby. Creates good prints with little effort. Great value for money.

What a fantastic item this has turned out to be, allows creating of detailed and intricate pieces, very easy to set up, intuitive settings for printing. Overall great bit of kit

I'm new to 3D printing, so bought a highly regarded printer to make the introduction easy.The quick start guide gets the printer put together, a basic setup operation, and printing of a provided, very forgiving model.When I tried to print other models, it was fail after fail. The instructions were totally inadequate and I learned much from online videos, of which there are plenty. Following these tips, my printing has dramatically improved as has my confidence in leaving the printer to get on with the job. It can be a slow process and watching the model slowly appear is hypnotic. Be careful or you will lose a lot of time.I certainly recommend this printer, but do your research on video sites so that you are able to set it up and run it properly. It is a brilliant machine, but it took me a long time to get there.

The media could not be loaded. After nearly four years of almost continuous use my Ender 3v2 died.Looking around and talking to friends I found this Ender 3v3 se. I have always been a bit dubious about printers that self level. Not really sure that could do the job properly. Reading online I see that reviews have always been fairly mixed.My experience with this printer though is 100% perfect. It took about 15 minutes to get the machine from its box, set up and printing. The cat in the photos was produced in just over an hour.Amazing quality, speed and ease and use. Absolutely love it!If you are looking for a new 3d filament print you cannot go wrong with this model.

Okay, had it for a week before i unpacked it as I needed to get a table to place it on, last week I put it together and up until today I have been printing with no problem.Put something on to print last night to get up this morning to a major failure... And a error codekey:2194.Sorted the 2194 problem and started to get some decent prints then yesterday I had what they term the blob of death..... The entire hot end was covered in filament basically destroying the head. So bought a new hot end, why do they hot glue all those ribbon connectors - one got damaged because of it when replacing the unit... It's now a dead printer... and it's just over a month old.I'm out of pocket as I have bought loads of spare filament and upgrade parts like the camera...WASTE OF MONEY - DON'T BUY IT - but they may know because it is no longer available to buy - go figure.... Anoyed.....Update, after spending loads of money on spare to get the thing up and running again it still is not.Very badly designed - very poor after sales service with a warranty that is basically worthless all it is fit for is the bin..For the price of this machine you may as well add the extra few dollars and get something that is not only cheaper for spares but has a full customer back up and warranty... I ended up with a Bambu A1 and a month in still going strong unlike the KE that is for the skip.Buy at your own risk

Very good printer just remember to check the screws are still tight on upright on the sides after a lot of printing because thay do come loos after time

Wonderful thank you

Brilliant once learn all about them and how they work recommend going on utube and have look all about them I love mine.