System Sensor 5600 135 Degree Fixed Temperature Rate-of-Rise, Single-Circuit Mechanical Heat Detector with Plain Housing

Exactly what I needed. New house did not have garage/utility room covered for fire. These areas tend to be drafty so a smoke detector is not appropriate, but a 135F with rate of rise is. Tested the ROR with a hair dryer, works perfectly.

Great sensors. Replaced 20+ year existing ones.Very solid mount - no chance of falling or getting lose by itself.Tested Rate of Rise with Hairdryer Method - working fine.

I just got one for the new house. Have been using these in my old place for 5 years with no false alarms. Good piece of mind in the garage over the cars and in the attic when monitored 24/7 by a good alarm system. Attic fires can get you killed because living space smoke detectors may not be triggered by fires in you attic or garage before it's too late to bail out.

INSTALLED THIS DETECTOR ON A LOW CEILING TOO CLOSE TO A STOVE AND WHILE THE EXHAUST FAN WAS OFF THE RATE OF RISE DETECTOR SENSED THE TEMPERATURE RISING QUICKLY : (FOUR BURNERS GOING IN STOVE) AND SET OFF MY ALARM. THE UNIT RESET AFTER THE TEMP WAS NORMAL AGAIN AND THE FIXED 135 SENSOR WAS NOT DAMAGED....GOOD HEAT DETECTOR THAT MUST BE INSTALLED CORRECTLY..THAT IS THIS DETECTOR SHOULD NOT BE UNSTALLED IN AREAS WHERE TEMP RISES QUICKLY....FOR SUCH AN INSTALL A FIXED ONLY DETECTOR MAY BE BETTER SUITED. RECEIVED IN GOOD CONDITION/ PACKAGING IN A TIMELY MANNER. OVERALL GOOD EXPERIENCE

Using this in may garage. I work in my garage a lot. I cant use a smoke detectors because cutting and welding will set them off. These should be required in everyone's attached garages. If your car catches fire at night while you are sleeping, how long until you find out?

This detector is made to work connected to an alarm system,it does not have its own alarm.It is totally mechanical, it means that it has no electronics inside, therefore it does not require power.It only has a normal open contact with two terminals that are in the sensor, not in the base. Although it only has two terminals, it can be connected together with four-wire sensors in the same alarm zone.It is activated by a sudden increase in temperature (ROR) or when the temperature exceeds 135 ° F. When activated by ROR, it reset automatically but when activated by temperature the disc is dropped and can not be reset. you have to replace the detector.Este detector está hecho para funcionar conectado a un sistema de alarma, no tiene alarma propia.Es totalmente mecánico, significa que no tiene nada de electrónica dentro por lo tanto no requiere alimentación.Solo tiene un contacto normal abierto con dos bornes que están en el sensor, no en la base.Si bien solo tiene dos terminales se puede conectar conjuntamente con sensores de cuatro cables en la misma zona de alarma.Se activa por aumento brusco de temperatura (ROR) o cuando la temperatura supera los 57°C, Cuando se activa por ROR se reinicia automáticamente pero cuando se activa por temperatura se cae el disco y no puede volverse a poner en su lugar, hay que reemplazar el detector.

Worked exactly as advertised, delivered exactly when they said they would. Easy to install and test.

It was as expected. Worked fine.