Jabsco 50070 Series Marine Impeller Puller

とても狭い条件でしたので使えるか心配でしたが少し加工をしましたがヤンマー4LHのインペラが取れました。劇的にやりやすいのでお勧めです。

Good quality. You get what you pay for. I ordered a Seadog and it failed( seized ) first use because the metal was too soft.The Jabasco is quite a bit more expensive but 3 times the quality.

After ruining two impellers over the last couple years when it was time to winterized, I asked the mechanic at a local Malibu dealer how he takes the impellers out without destroying them. He showed me this puller and I ordered one right away. This fall was my first time using it and it worked like a charm. It was easy to get into the small space at the back of the engine and didn't damage the impeller at all. If you live in an area that requires you to winterize your boat I'd highly recommend this puller which will allow you to save you impeller to reuse.

after struggling for hours upsidedown through the floor hatch above my Yanmar 440 diesel, i finally broke down and bought this impeller puller. It took me less than 30 minutes to remove the impeller once i got this tool. Worth the money.Only suggestion back to Jabsco is that they make the finger tighteners smaller profile so that it's easier to get into tight spots.

If you own a boat, chances are that the engine has an impeller in the cooling water system. If you're like me, changing the impeller was one of the most frustrating jobs I had to do, and thus ofter put off. That is until a fellow cruising sailor loaned me this tool. I could not believe how easily the old impeller came out. My engine (Yanmar) has a rather small clearance between the water pump and starter, so I simply removed the large screw and used it without, pulling by hand. Still easy. Just be sure you get the right diameter tool. I makes a big difference. Also, This was the best price I found for this wonderful tool. Worth it at any price, though!